KCP Construction Grout Non Shrink

D.o.T. Highways Spec:- 2601 Compliant.

KCP Construction Grout is a non shrink, high strength cementitious grout comprising of low alkali high specific surface area Portland cements and other cementitious binders combined with high purity aggregates and a system of compatible admixtures to achieve high in service performance. This grout has high flow characteristics to achieve penetration and levelling with no bleed and zero shrinkage when placed at 0.22 water solid ratio.

Uses – KCP Construction Grout has been specifically designed for anchor or base plate grouting, under machinery and stanchion plates, grouting rails and bridge bearings, fixing bolts, parapet rails etc. It can also be used in its plastic state as a bedding mortar.

Equivalent Sodium Oxide is less than 3.0kg/m³ High ultimate strength Shrinkage compensated Can be used for grouting sections up to 100mm thick Chloride free High fluidity – can be pumped or poured

Yield – The approximate yield of mixed grout per tonne of dry powder is 0.61m³. The approximate quantity of dry powder required to produce 1m³ of set grout is 1.65 tonnes. This equates to 15.2 litres per 25kg of dry powder. These figures do not allow for site wastage.

Flow Characteristics  – A typical flow-channel figure for KCP Construction Grout would be in the range of 500mm. (The quoted set and flow characteristics are dependent on temperature and type and duration of mixing. Temperatures higher or lower than 20ºC for example, will result in reduced or extended setting times).